Feature Requests

In some designs it is not suitable to have 1 AHU serving 1 zone due to large heat gains, the ability to split the coil load between 2 is required.

I would like to use more than 1 supply duct to feed a branch in a SDHV system and a ventilation system.

You can now create a grille schedule but cannot add a grille reference when placing the grilles, so that it can pull through to the schedule, which would be helpful.

Include flat oval ducts into the ductwork sizing. Currently only square and circular ducts are included.

MVHR units and HVAC manifolds with vertical inlets and outlets to mimic specific units. This would allow for more accurate space modelling.

Currently grilles and diffusers can't be referenced like AHUs. This would assist in providing mark-ups for drafting. This reference should show up instead of the green diffuser text that is currently shown. Maybe these references could be auto populated as they are placed.

As we do a lot of residential schemes, it would be good if there was a library of plastic ductwork and fittings which included sizes 204x60mm and 220x90mm.

Ability to add MVHR that allows you to input the efficiency without the need to turn on heating/cooling as this isn't required for most MVHR. You can currently do this by using the "percentage of ventilation heat loss recovered" under the calculation method settings but this won't work in projects where you have multiple MVHR or different ventilation system within the project. I have detailed this explanation in my email to Martins (CC Michael and Jordan) dated 10/11/2025